Electrical contractors work at height throughout every phase of a commercial project — from underground rough-in near open excavations to overhead conduit runs on scissor lifts and scaffolding. GCs require a Fall Protection Plan that covers these varied work environments.
Your plan can't be a generic fall protection template. GC safety coordinators will check that it addresses the specific heights, locations, and protection methods relevant to electrical scope — not just generic guardrail and harness language.
Working from ladders, scaffolds, or aerial lifts to install conduit, cable trays, and junction boxes above 6 feet.
Core-drilled holes, cable chases, and sleeves through floors and roofs create fall hazards until covered or guarded.
Switchgear and panel installations in mechanical rooms often require ladder or scaffold access near unprotected edges.
Scissor lifts and boom lifts used for overhead rough-in require PFAS tie-off per manufacturer and OSHA requirements.
Electrical work spans nearly every floor and elevation of a commercial building. GC safety coordinators expect your Fall Protection Plan to identify where your crew will be working above 6 feet, what equipment they'll be using to access those areas, and how fall protection will be provided at each location.
In addition to the 10 standard sections of every SafeDocs Fall Protection Plan, your plan will address these trade-specific elements:
Aerial lift and scissor lift fall protection requirements
Open penetration and floor opening protection
Ladder safety for overhead panel and conduit work
Scaffold tie-off procedures for electrical rough-in
Temporary lighting and work in partially enclosed spaces
Yes. OSHA requires fall protection on scissor lifts when workers are above 10 feet. Most manufacturers also require PFAS tie-off. Your GC will require a Fall Protection Plan regardless of the access equipment you use.
If any of your work is above 6 feet on a commercial job site, the GC will require a Fall Protection Plan. Low-voltage work often involves overhead cable tray runs that require the same fall protection as power distribution.